POE576U-8UP-N Phihong 8 Port 72W per Port Midspan POE576U-8UP for 10/100/1000 Base-T Networks

• INPUT
• Input Voltage Rating - 100 to 240VAC
• Input Voltage Range - 90 to 246VAC
• AC Input Current - 9.0A (RMS) 90VAC at maximum load, 4.25A (RMS) 230VAC at maximum load
• AC Input Frequency - 47 to 63Hz
• Leakage Current - 3.5mA maximum at 264VAC and 60Hz
• Max In-Rush Current
  • 30A for 115VAC at maximum Load
  • 60A foe 230VAC at maximum Load
• Total Output Power - 72W per port/576W Maximum Total Power
• Ripple and Regulation - 250mV maximum
• Efficiency - 75 percent (typical) at maximum load, and 120VAC 60Hz
• Hold-Up Time - 16mS minimum 120VAC and maximum load
• Transient O/P Voltage Protection - 60V maximum at switch on and off at any AC line phase
• Turn-On Delay Time - 20sec maximum load, 120VAC 60Hz
• Isolation Test
• Primary to Secondary: 4242VDC for 1 minute
• Primary to Ground: 2121VDC for minute
• Secondary to Ground: 2121VDC for 1 minute
• Immunity EN50082-1
• ESD: EN61000-4-2 Level 3
• RS: EN61000-4-3 Level 2
• EFP: EN61000-4-4 Level 2
• Surge: EN61000-4-5 Level 3
• CS: EN61000-4-6 Level 2
• Voltage Dips: EN61000-4-11
• Harmonic: EN61000-3-2
• IEEE802.3af/at Interoperability - If 25L Ohm is detected the unit operates in "IEEE802.3at mode" 33.6W 2 pair powering. 12.5K detection resistance required for full power.
• Short Circuit Protection - Outputs equipped with short circuit protection and overload protection as per 802.3af specification except at maximum average current is 1.29A. The output can be shortened permanently without damage.
• Over Temperature Protection - Automatic shutdown without damage
• EMC
• EN55022 Class A, FCC Class A with UTP cabling
• EN55022 Class B, FCC Class B with FTP Cabling
• SNMPv2c management port Interface - NIC interface for remote management via secure IP access
• Input Connector - AC Input IEC320 C14
• Warranty - 1 Year

POE576U-8UP-N Specifications PDF